Setting System Board Jumpers 6-3
4.
You may have to remove any installed expansion boards
to access the jumper (see “Removing an Expansion
Board” in Chapter 5).
5.
Remove the jumper block from pins 1-2 and set it on
pins 2-3. We recommend that you use needle nose pliers
to move a jumper.
6.
Replace the access cover (see “Replacing the Access
Cover” in Chapter 5).
7.
Connect system power cables and monitor.
8.
Power on the system.
The system enters Setup and the Maintenance menu
appears. You can disable the user and supervisor
passwords.
If you removed the jumper, the system attempts to
recover the BIOS. A recovery diskette is needed.
9.
Power off, unplug the system and monitor, and remove
the access cover.
10.
Remove the jumper block from pins 2-3 and replace it
on pins 1-2.
11.
If you removed any expansion boards, replace them
(see “Installing an Expansion Board” in Chapter 5).
12.
Replace the access cover. Reconnect the system power
cables and peripheral devices.
13.
Power on the system.
14.
Run Setup (see Chapter 4, System BIOS and Utilities).