Programming
11-10 : Service Code Setup (for System Administrator)
146
◆
Networking
Conditions
None
Feature Cross Reference
Refer to chart above.
Telephone Programming Instructions
To enter data for Program 11-10 (Service Code Setup (for System Administrator)):
1.
Enter the programming mode.
2.
11 10
3.
Enter the number of the item you want to program.
4.
Enter data for the item you se HOLD.
5.
Enter data for the next item in the program.
OR
Press MSG once to enter a new item number.
OR
Press MSG until you’ve exited that series’s programming section.
34
Set Caller ID Refuse
De
Þ
ne the service code to be used to enable/disable
the Caller ID call refusal for the trunks which are pro-
grammed in Program 14-01-27 to 1.
No Setting
14-01-27
35
DID Mode Switching
Assign the service code to be used to manually change
the time pattern for a DID number.
KST, SLT
No Setting
11-10-01
NT-Mode_Switch *01
back
↑
↑
↑
↑
↓
↓
↓
↓
select
11-10-nn
nnnnn
←
←
←
←
→
→
→
→
Item
No.
Item
Terminals
Default
New
Related
Program
Summary of Contents for Aspire L
