English−15
Connect the cables
OOTE: •
Do not connect or disconnect cables when turning on the monitor's main power or other external
equipment's power as this may result in a loss of image.
•
Do not use an attenuating (built-in resistor) audio cable. Using an audio cable with a built-in resistor
will lower the sound level. Use an audio cable without a built-in resistor.
e recommend turning off the monitor's main power before connecting the speakers, external devices, or USB
cables.
1.
Connect the USB hub
•
Connect one end of the 10cm USB cable, supplied with the monitor, to the USB
Type-B input marked with "Hub," located above the external speaker terminals.
Connect the other end to the USB Type-A input marked with "USB 1".
•
The red LED on the USB hub will light up.
OOTE:
If connecting to an external PC, use the 3m USB cable supplied with the
monitor. Connect the USB cable to the USB Type-B input marked with
"Hub" to a USB Type-A input in the external PC.
2.
Connect the external speakers
•
Connect the audio cables to the terminals on each speaker and to the speaker
terminals on the side of the InfinityBoard
®
.
•
The red terminal is plus (+), and the black terminal is minus (-).
