Neat WALL Famiy, Technical Handbook

Page: 45 / 56

neat
45
NE41 11014-02 v4.1 WALL - Technical Handbook
6.1.1 General idea about the setup
The D-POS unit (with a connected D-POS Antenna) registers who approaches the
door. The caregiver is automatically given permission to open the door (i.e. it unlocks
automatically when the caregiver approaches the door) while the caretaker must
press the red button on the PUSH unit to unlock the door.
When the care taker presses the PUSH button the door unlocks (Relay 1 is activated
and unlocks the door lock) and Relay 2 is activated to light the lamp at the reception
desk
In this example Relay 1 controls the door lock mechanism where Relay = Close opens
the door and Relay 2 is connected to the light indication where Relay = Close lights
up the light indication.
Setting up the hard- and software
A good approach would be to:
1. Configure the units/parts in the setup.
2. Define appropriate actions in PUSH.
3. Determine behaviour for buttons and inputs.
4. Determine the Radio events.
First configure the D-ATOMs, then the D-POS and lastly the PUSH unit.
6.2 D-ATOM Care taker
General tab
Picture 46. General settings of D-ATOM for care taker.
The settings to modify here are:
• New Radio ID code (Radio ID code 1000 is assigned).
• Check
Radio Test Alarm Active
.
• Check
Alarm Button enabled
.