INKA, IOR, REPO & LINK
The alarm type for transmitted alarms when a radio message is received is configured in the fields of
the column
alarm type
under the
radio input
tab.
IOR
REPO
Configure alarm type for transmitted alarm
when a radio message is received in
position 1…8
Select alarm type from the list in list box
151…158
IOR
REPO
Configure alarm type for transmitted alarm
when a radio message is received with
the
fixed input
ID code
Select alarm type from the list in list box
159
IOR
REPO
Configure alarm type for transmitted alarm
when a radio message is received that
does not have a pre-programmed ID code
Select alarm type from the list in list box
160
3.4.3 Number of Transmissions – Radio Packages
When a radio message is transmitted, the INKA, IOR or REPO unit that transmits the message waits
for an
acknowledge
message from an alarm receiver. If no
acknowledge
is received, the same
message is transmitted again and again until an
acknowledge
is received, or until the maximum
number of transmissions has been reached.
Each transmission of the same message is called a
radio package
. A radio package can be short or
long. The maximum number of short and long radio packages can be configured individually with IOR
Programmer. The short packages are always transmitted before the long packages.
Each package in the same message contains the same information, but only long packages can be
received by battery powered equipment and portable transceivers TREX or HOME. Each short
package takes approximately 60 ms to transmit, and each long package takes approximately 560 ms
to transmit. The time between two packages is 75 ms.
The parameters for the number of short and long packages in each radio message are found in the
radio
section under the
preferences
tab in IOR Programmer.
INKA
IOR
REPO
Configure the maximum number of short
packages in a radio message
Enter the number of short packages in
text box 311
INKA
IOR
REPO
Configure the maximum number of long
packages in a radio message
Enter the number of long packages in text
box 312
In the table below, recommended settings for short and long radio packages are listed for some
common system configurations.
Recommended Settings
Short
Packages
Long
Packages
TREX system, one REPO unit
0
6
TREX system, many REPO
units
0 3
NEO system, one REPO unit
6
6
NEO system, many REPO units
3
3
Technical Handbook for the IOR Family (firmware v20.x), document number NE41 06007-02 v1.0
30