NDC BenchMike Pro, Instruction Handbook Manual, Page: 58 / 146

4-6 BenchMike Pro 2025/2050 & Z-Mike Pro 4025/4050 Instruction Handbook: Setup
Variation :
This graph shows the size variation between positions.
For all but the final position “variation” is the absolute val-
ue of the difference between the next measured size and
the current measured size. For the final position “varia-
tion” is the absolute value of the difference between the
first measured size and the final measured size.
4.4 Measurement Icon
Touch the Measurement Setup icon in the upper right hand corner of the screen to display the
menu shown. This icon allows you to quickly access the settings for measurement parameters. Note
that you can access these same screens by selecting Set-
up, then Measure, then Measurement.
See the Measurement Functions section in Setup for fur-
ther information about these parameters.
Default settings are shown in the table below.
Tab Parameter Setting
Type Type Diameter
Type Method Single
Type Part Mode Disable
Averaging Rate 2.00 Seconds
Averaging Delay 0.00 Seconds