SHOULDER PACEMAKER
TM
- User Manual 04-06EN
17
Refer to the specific user manuals on the management of the Shoulder Pacemaker Control Software 1.1.2.0 supplied with the SPM01K2
kit or on using the app MySPM supplied with the SPM01K3/SPM01K4 kit
The Basic Instructions described above remain valid even in wireless mode. The wireless mode requires the insertion of the receiver in the
laptop, in case of SPM01K2 kit, or the activation of BLE connection, in case of SPM01K3/SPM01K4 kit and the launch of the installed
software/application. Once the wireless program has started, the number of red LEDs on the bar corresponds to the current stimulation
voltage level set and the central yellow LED is on and steady. Pressing the button the device returns to the program selection status. This
specification allows the stimulation to be stopped immediately and is a safety measure with respect to any software anomalies.
PRODUCT MAINTENANCE
Depending on the intended use and on the conditions of use, storage and recharging of the product described in this manual, the expected
lifetime span of the Shoulder Pacemaker
TM
device is 2 years.
CLEANING
Make sure that all the contents of the kit are placed in the proper packaging. If sweat is present on the device, use a soft dry cloth and a
solvent-free detergent to remove them before use. All material must be placed in clean areas after use. In such areas there must not be great
temperature changes or wet areas. Hygienize the elastic band after repeated use on the same patient. If the device is used on different people,
sanitize the elastic band between use on different subjects.
RECHARGE
The stimulator contains a lithium battery that must be charged before each use.
Before recharging the device, make sure that the stimulator is switched off. Proceed by disconnecting the conductive cables from the
stimulator and insert the USB charging cable in the space provided. Then connect the cable to a power supply capable of delivering 5V and at
least 275mA.
Wait until the device has been recharged, signaled by the complete lighting of the red LED band.
REPLACEABLE PARTS
The replaceable parts of the system, which require the intervention of technical assistance, are listed: stimulator, conductive cable and
charging cable.
In case of a malfunction, contact the technical assistance that will evaluate the replacement of one or more replaceable parts. Replacement of
parts of the device can be done only through our service center.
TECHNICAL ASSISTANCE
Technical assistance is provided by our team. Any problem encountered must be reported to the following email:
[email protected]
Our team will provide technical assistance regarding all aspects of the device and software supplied and will also take care of replacing any
damaged parts of the device.
PRODUCT WARRANTY
The Shoulder Pacemaker
TM
device is covered by a warranty of 1 year, which comes into effect on the date of purchase of the device (proof of
purchase is required). The warranty does not apply to the electrode pads and carry cases.
Within the warranty period, manufacturer will replace your faulty Shoulder Pacemaker
TM
device or accessories at no charge (except shipping &
handling fees in some cases), provided that the product:
• Has been used for the intended purpose and in the manner described in this manual.
• Has not been connected to an unsuitable power source.
• Has not been subjected to misuse or neglect.
• Has not been modified or repaired.
• Has not been damaged further by shock.
Legal rights are not affected by this warranty.
WARNING: No modification of this product is permitted
WARNING: If for any reason water or liquids enter into the USB port of the device, immediately contact our
customer service.
Summary of Contents for SHOULDER PACEMAKER SPM Series
Page 1: ......
