24
Large Basket Angled Module
Changing V-Bagwell Orientation
This procedure should be done before installing the Large Basket Angled Module (V-
Bagwell) to the Corner Bagwell. To change the orientation of the V-Bagwell, follow these
steps:
Note:
For the purpose of illustration only, this procedure shows images using Left-hand
(LH) orientation.
1. Do the following:
a. Remove the fences from the Large Basket (Basket) Module. For more
information, refer to
b. Remove the V-Bagwell. For more information, refer to
page 29 .
Note:
If the V-Bagwell is equipped with a Bottom-of-Basket (BoB) Camera,
ensure that the camera cable is disconnected from the SelfServ Checkout unit.
For more information the changing the orientation of the Bottom-of-Basket (BoB)
Camera, refer to
7358-K582 Bottom-of-Basket Camera Kit Instructions
.
2. Remove and install the blanking plate on the side cable access hole by doing the
following:
a. Detach the blanking plate by removing two (2) screws.
