Maintenance Instructions
Lubrication
NCR 5635 Spray Currency Dispenser Service Manual
4-49
NCR - CONFIDENTIAL AND PROPRIETARY
Use pursuant to Company Instructions
6
Apply lubricants using the most convenient method when none
is specified, that is by brushing, dipping, or oil can. Spraying is
not recommended.
7
Lubricate all spring hooks and spring studs with lubricant B.
8
Working clipped or riveted assemblies should not be lubricated
before riveting but only after all processes, handling, or storage
involving exposure to dirt or serious atmospheric
contamination are past.
9
On assemblies that have shafts on which one or more moving
parts are assembled, lubricate both the shaft and the hub areas
on each part with the specified lubricant.
10
Lubricants can cause serious deterioration of rubber. Avoid
contamination of drive belts and drive rolls.
Caution
Make sure that no lubricant spills on to the teeth of gears as this may
impair their performance.
Spray Module
4
Lubricate as follows:
●
All plastic bearings (before assembly) - with A.
Pick Module
4
Lubricate as follows:
●
Drive segment, inside hub, pivot stud - with A
●
Gears turning on stationary stud, on the stud, in the bore - with
B
●
Cam cluster, bore and pivot stud - with B
●
Pick line, bearing faces - with B
●
Pick line hub bearing surface - with B
●
Plastic bearings (before assembly) - with A
●
Cassette latch stud - with B.
master.bk Page 49 Wednesday, March 27, 2002 9:35 AM