Naxa NAS-3070, Instruction Manual

Page: 10 / 12

Page 10 Naxa Electronics
Troubleshooting Guide
This guide lists common problems and their solutions.
Please refer to this guide before requesting service.
If you need further assistance, please contact Naxa
Technical Support (www.naxa.com/naxa_support/).
Symptom Possible Cause Possible Solution
There is no
power. The battery is
exhausted. Connect the unit to a
USB power source to
charge it.
The Power switch is
set to OFF. Make sure that the
Power switch found on
the back of the unit is
set to the ON position.
The device
is unable to
connect to the
speaker. The speaker is not
in pairing mode. Reset the speaker
(turn it off and then on
again.) Press PAIR until
the status indicator is
flashing quickly blue.
Bluetooth may be
disabled on your
device. Make sure Bluetooth is
enabled on your device.
Turn it on if it isn’t.
Symptom Possible Cause Possible Solution
The device is
connected but
there is no
sound. The AUX connector
may be in use. Disconnect all cables
from the AUX input
connector [7] on the
back of the speaker.
Your device may be
beyond the effec-
tive range of the
speaker. Move closer to the
speaker. Range may
be affected adversely
by environmental
conditions.
Your device may
not be in playback
mode. Ensure that your device
is operating correctly.
Start playback on your
device.