16
USEAGE
Mow only in daylight or in good artificial light.
Do not mow during rain, especially during a storm. Avoid mowing wet grass.
Always make sure that your legs stand firmly on the slope.
Come on, never run. Remember to keep a secure position.
Mow across slopes, never up or down.
Be very careful when changing the direction of travel on a slope.
Do not mow on excessively sloping slopes.
Pay special attention when reversing or pulling the device towards you.
Turn off the machine if it is to be tilted or when moving it over non-grass surfaces and when transporting it to
the mowing site and back again.
Before transporting the mower, cool the engine, drain fuel and oil.
Do not use the device with damaged covers or housings or without safety devices, e.g. attached covers
and / or grass containers.
Start the engine according to the instructions, making sure that the feet are away from the cutting tools.
Do not start the mower when it is tilted, unless it is necessary to start in high grass. In this case, press the handle
to lift the front of the machine, but only as much as is necessary, and then slowly lower the mower to the ground.
Make sure that both hands hold the handle securely throughout the operation.
Attention! The B&S engines cannot operate on a slope above 15
º
.
Do not keep your hands and feet near rotating parts. For rotary mowers, make sure that the discharge opening is not
blocked at all times.
When starting the powered mower, do not pull on the drive start lever.
MAINTENANCE AND STORAGE
Warning
Before carrying out any repair or maintenance operations, make sure that the mower has the spark plug high voltage
cable removed and there are no children or third parties nearby.
Remember that there may be fuel in the machine's tank. Safety rules for handling fuel are described in this manual
in the section "Safety in handling fuel".
Keep all nuts, bolts and screws in good condition to make sure that the device will work safely. Check the grass
container often for wear or damage.
For mowers, make sure you use the right type of knives.
After finishing work, the mower should be cleaned. The fuel tank must be empty. Place the mower on the handle
(spark plug up). Use a brush to clean the inside of the mower housing from grass and dust, and possibly protect metal
parts with anti-corrosive agents. You can clean the entire mower with a damp cloth and, if necessary, protect it with
varnish paste.
The mower must be stored in a well-ventilated room in a dry, dust-free place. Check that the grass basket is empty and
properly cleaned. Rotting grass can damage the basket.
Only a functional mower should be stored, if necessary, the faults must be rectified before storage.
If the mower is equipped with a battery, remember that the optimal storage conditions for the battery are 10 to 21° C, low
humidity, 50% charged battery.
IN CASE OF AN ACCIDENT OR FAILURE
In the event of an accident, stop / turn off the machine immediately and call for help (if required).
In the event of a fault, stop / turn off the machine and contact an authorized service center to avoid the fault.
Summary of Contents for 5000S
