11 | Confidential
1. Remove any interior/under dash trim necessary to gain access to vehicle’s wiring as well as all
areas where interconnecting wire harnesses will need to be located.
2. Attach fuse holders to the Constant and Ignition wires of the Qube’s harness.
3. Individually isolate any wires in the Qube’s harnesses that will not be used during installation.
4. It is strongly recommended to locate and connect constant power and ignition wires at the
ignition key switch connector behind ignition key cylinder. (
Note: If the ignition switch harness is not
accessible, amperage restriction exists, or the vehicle has an electronic starting system, constant power and ignition
connections can be made at the interior fusebox.)
5. Use a multimeter and the chart on next page to identify Constant and Ignition wires.
Identifying Correct Wires
Summary of Contents for Qube4
