Naviter Oudie 4 Manual Download Page 106

Page: 106 / 158

Oudie 4

101

Navboxes are setup separately for Map 1 and Map 2 views. That is because normally you will want to use
the two map views for two different reasons. One could be general navigation while the other one is
approaching the waypoint where details are important. You will require two different settings for which
Navboxes should be displayed in these conditions.

Through this dialog you can select which of the available Navboxes you wish to display on the active map.

The Combo box allows you to choose from a sub-group of navboxes so you can more easily select or
change the ones you want. One sub-group is also "Currently visible navboxes" for example.

Navigation navboxes:

Target name

(Target) = Name of the selected waypoint

Distance to target

(Dis) = Distance from your position to currently selected target

Steering course

(To) = Difference in degrees between Bearing to target and Track over ground

Bearing to target

(Brg) = Direction towards the selected waypoint

Magnetic bearing to target

(MagBrg) = Magnetic course to fly to get to the target*

Track over ground

(Trk) = Direction of the flight (true)

Magnetic Track over ground

(MagTrk) = Current magnetic course of flight*

Radial

(Radial) = Magnetic direction from the waypoint to the current position

Speed over ground

(GS) = Groundspeed. This value is negative if the difference between heading

and track is more than 90 degrees
.

Local time

(Time) = UTC time from GPS corrected by time zone set in the

Units

dialog

Arrival time

(ETA) = Estimated time of arrival to the selected waypoint*

Estimated time enroute

(ETE) = Estimated time to go to selected waypoint*

Nearest airport

(Near Apt) = Name of the nearest airport. Tapping on this navbox opens airport

properties dialog*
.

Inverted Distance to target

(DisInv) = Distance to selected target in inverted units as currently

selected units. If your units are kilometers, this distance will be in nautical miles*
.

Dist to TP

(DistTP) = The distance from your position to selected center of turnpoint

Distance to OZ

(DistOZ) = The shortest distance from your position to currently selected Observation

Zone (Cylinder, Line, FAI sector)*
.

Steering course to last thermal

(ToLT) = Difference in degrees between Bearing to last thermal

and Track over ground
.

Dist to last thermal

(DisLT) = Distance to the last thermal

GPS Status

(GPS) = It displays the status of the GPS signal. It can be either NODATA, BAD, OK, 2D,

3D/x
.

Battery info

(Bat) = Displays battery status. It can be either Full, Chrg (Charging), Ext (External) or a

percentage value of the battery status
.

Distance from takeoff

(dToff) = distance from your position to the Takeoff

Altitude navboxes:

Altitude QNH

(Alt) = Altitude above sea level

Flight level

(FL) = Altitude above standard atmosphere pressure

Height AGL

(Agl) = Altitude above the ground elevation vertically below the glider position

Altitude m QNH

(Alt m) = Altitude in meters QNH regardless of the units you are currently using

Altitude ft QNH

(Alt ft) = Altitude in feet QNH regardless of the units you are currently using

Altitude QNH 2.5 h

= it´s altitude you have been 2,5 h ago from current time*

Ground elevation

(Gnd) = Terrain elevation vertically below the glider position

GPS Altitude =

GPS altitude

Arrival altitude

(Arrival) = Expected Arrival altitude at the selected waypoint calculated by taking the

distance, MC, wind, glider polar, bugs and ballast into account. It is corrected for reserve altitude.
"Arrival altitude" will be positive when the glider is above the calculated glide slope, and negative when it

113