49
Configuring the Remote Controller System
4.1 Included Items
When you open the box, you will find the following
items with the remote controller. Check the box for
each of the following items before installing the
remote controller.
Remote Controller
Extension Cable
2 Tapping Screws
Wall Mounting Bracket
Multi Remote Controller
Cable (optional)
4.2 Connecting the Extension
Cable
1. Connect one end of the extension cable to the
port on the front panel of the water heater.
2. Pass the other end of the extension cable
through the hole in the bracket.
3. Connect the end of the extension cable to the
cable connected to the remote controller.
Note
●
You can connect up to 2 remote
controllers if necessary. (Optional)
●
Connect the wiring from the second
remote in parallel with the existing
remote controller. One remote must
also be designated as the MAIN
controller. For more information,
refer to “4.5 Multi Remote Controller
●
The length of the extension cable is
7 ft (2 m) and can be extended using
18AWG wire up to 300 ft (91 m).
4.3 Attaching the Wall Mounting
Bracket
1. Affix the bracket securely to the wall by
fastening 2 screws to the wall or to the 2 holes
in the wall receptacle.
On the wall
In the wall receptacle
2. Hang the remote controller on the bracket by
aligning the hooks.
4. Configuring the Remote Controller System
Summary of Contents for NHW700
Page 83: ...Memo...