32 Installing the System Piping
If the wall cannot be drilled, secure the NaviCirc to the wall using
the bracket with a double-sided tape and primer.
1. Using a cloth remove the substances on the bracket where
double-sided tape is attached, and the wall where the
NaviCirc is attached.
2. Pop the ample by snapping the primer stick into half. If the
ample is properly popped, you will be able to smell it from
the head of the primer stick.
3. When the liquid comes out of the head of the primer stick,
apply primer to the back of the bracket and the wall where
the NaviCirc is attached.
4. Attach the double-sided tape to the bracket, and attach the
bracket to the wall.
1
2
double-sided
tape
Installing the NaviCirc NOT Connected to a Tap
1. Cover the
HOT OUT
connection with the ½” stainless cap
and washer.
2. Connect two ½” flexible hoses to the
HOT IN
and
COLD IN/
RETURN
connections.
3. Install an air vent on the
COLD OUT/CLOSED
connection.
Air Vent
COLD OUT/
CLOSED
HOT OUT
HOT IN
COLD IN/
RETURN
½” stainless cap
CAUTION
You must use the provided washers to seal ½” flexible hoses
and ½” stainless cap. Failure to do so may result in water
leaks.
Note
An air vent is not provided.
4.4.5 Securing the NaviCirc
The NaviCirc can be secured to the wall using a bracket or
anchors and screws depending on the installation environment.
Securing the NaviCirc Using a Bracket
CAUTION
If the surface of wall (tiles or metals) is not smooth, the
double-sided tape might not be attached to the wall
properly. If the wall is wooden, drill the wall and secure the
NaviCirc to the wall using anchors and screws. Also, select
the installation location considering the ½” flexible hose
length (500 mm). For more information, refer to “Securing
