E308 Smart ID card_User manual_V1.0.0
Naviecare
www.naviecare.com
- 9 -
6. Device Operation guide
6.1 Power on
Press and hold 3S to turn on the device; RGB RED LED lights up for 5 seconds after turn on,
accompanied by a startup ringtone
6.2 Broadcast battery percentage
After powering on, press the POWER button for 3 times (400ms once) to broadcast the current
battery percentage of the device.
6.3 Power off
Press and hold the POWER button for 8S, the motor vibrates once for 500ms, and the device is turned
off with the shutdown ringtone.
6.4 SOS in emergency
Press and hold the SOS button for 3s to send a SOS message , the motor vibrates for 500ms after the
SOS alarm is successfully sent.
6.5 Broadcast Platform Instructions
After the platform sends a message, the SOS button blue light flashes 3S once (when the voice
command is sent, the motor continuously vibrates 3 times), press the SOS button for 500ms to
broadcast the platform message.
6.6 Broadcast signal strength of device
Press the SOS button three times (400ms once) to broadcast the signal strength of device.
6.7 Inspection/Intelligent attendance
Inspection: According to the inspection task, short press the M key once, the device will broadcast
“Enter the inspection mode” and report the inspection data. After successful inspection, the M