LOCATION & REMOVAL
With the head unit now removed locate the power ISO
plug and the Black optical plug shown below.
Insert OPTICAL leads into TOOKI-POR loom and car loom
to create loop, see diagram below
To remove the (out) fibre optic cable from the factory con-
nector you will need to remove the black outer casing and
push out the blue locking insert. You will need to do the
same to insert the cable into the supplied loom. (shown in
previous fig)
Next plug in the power link loom into the car harness, plug
in the microphone (supplied) and insert optical plug into
the interface.
INSTALLATION
Firstly to determine if your PCM unit is compatible,
press and hold the MAIN & TRIP buttons to display
the PCM Software version. Should be 2.0 or above
Installation is made at the front unit.
To remove the head unit you will need to remove the
surrounding trim then the 4 screws securing the unit, as
below. Some models are removed with specific radio
keys.
TOOKI-POR is designed to work with a radio that has a
factory SIM card based GSM phone option rather than
Bluetooth. As such, certain functions displayed on the
radio are not supported by the TOOKI-POR.
The factory phone module (if fitted) will need
to be removed from its power and optical con-
nection (optical cables must be re-connected
to continue loop) This module is located under
the drivers (O/S) seat on all models. It is possi-
ble to install the TOOKI kit at the Factory
phone location and allocate 12v+ perm and
ground.
INTERFACE
CAR CONNECTOR
OUT cable from screen
IN cable from interface
1. Press TEL on PCM Radio.
2. “Tooki Searching” indicates no phone connected.
3. Start the pairing procedure on your mobile phone.
Make sure the Bluetooth feature is turned on. Con-
sult your phone’s manual for phone-specific pairing
procedures.
4. Once your mobile phone discovers Tooki xxxx (last
4 digits will vary), select and pair Tooki.
5. When prompted for a passkey, enter 6888 on your-
mobile phone.
6. Once pairing is complete, press TEL and select
“phonebook” Choose the phone you wish to pair, and
select. After a short while you should see your signal
strength indicator and phone book list on the PCM Ra-
dio. Pressing “Tel” will then show you your network pro-
vider and signal strength.
7. You may pair up to 5 different mobile phones. For
information on phone selection, section 6
8. To delete a paired phone select phone book, scroll to
the phone name you wish to delete, select the name
by pushing the rotary button. When the name is se-
lected scroll to “delete” on screen and you should
see the message “are you sure you want to delete”
select yes.
9. you may use any of the units hard keys as well as
the on screen lists to dial out.
OPERATING INSTRUCTIONS
