Current as of 2016-11-04
Instruction Manual for M67/M77 to
Bayonet Mount Converter
PN# 83213, 83215
F
OREWORD
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM, we pride ourselves in the ability to recognise the requirements
of professional as well as amateur underwater photographers and fulfill them
through the innovative designs of our products. We strive to achieve a high
level of user-friendliness by allowing stress-free installation and easy
operation of all important functions of the camera.
Please read this manual carefully before using the product, this will maximise
its performance as well as its lifetime.
W
ARRANTY
All NAUTICAM Products are warranted against any material and
manufacturing defects for two years from the date of purchase for consumer
use.
This warranty only applies to products purchased from authorised
NAUTICAM dealers and does not extend beyond the original retail purchaser.
To return your product for service, please contact your regional authorized
service centre(s). Please note that this warranty only applies when the product
is purchased in the territory where the service centre is located.
NAUTICAM does not hold responsibility for damage, of any nature, to any
equipment used with and/or placed within our products.
NAUTICAM accepts no liability for any loss of captured images or the inability
to capture images even if it is due to the malfunctioning of our products.
Unauthorised modifications and/or repairs of our products will automatically
invalidate the warranty.
I
DENTIFICATION OF
P
ARTS
*There are two alignment pins at the bottom of the holder, by relocating the
two screws to the threaded holes around the holder, the position of the
holder can be changed.
#83213 M67 to Bayonet Mount Converter is used as an example in this
instruction manual, #83215 will be slightly different in term of appearance.
I
NSTALL TO THE
P
ORT
Align the two positioning pins on the back of the converter with the slots on
the front of the port. Fasten the converter on the front of the port with the
tool provided.
Note: The position of the converter can be adjusted by relocating the two
positioning pins into the threaded holes around the converter.
M
OUNTING
L
ENS
Align the “I” mark on the lens with the “I” mark on the Converter and then
push it in.
Turn the lens clockwise until the “I” mark on the lens aligns with the WHITE
dot on the converter and a “click” sound is heard.
--- continue on next page ---
Lens release button
Fastening tool
Lens alignment dot
Positioning pins* (x2)
Threaded holes for
positioning pin (6x)
M67 / M77 thread
