Nautel XR6, Operation And Maintenance Manual

Page: 49 / 83

XR6/XR3 Operations and Maintenance Manual Operating the transmitter
Page 2-24 Issue 3.1 2013-03-14
Calibrating meters
To view the
Calibrate Meters
page, select
Settings
from the Main Menu ,
Hardware Settings
from
the General Settings menu ,
Calibration Settings
from the Hardware Settings menu , then
Calibrate
Meters
from the Calibration Settings menu.
Figure 2.18: Calibrate Meters page
Press the
Up
and
Down
buttons to scroll to the desired meter reading. (The VSWR meter does not
appear, since it is a calculated value and cannot be directly calibrated.)
To change a calibration value, press the
Edit
button and then use the
Up
and
Down
buttons to
increase or decrease the value. Record the associated
Scale Factor
value before and after the change
for future reference.
Calibrating analog meter
You can recalibrate the XR6/XR3’s analog forward power meter, if necessary, using the
Calibrate
Analog Meter
page.
Note: The transmitter is calibrated at the factory. Do not change calibration settings unless
absolutely required.
Notes:
The transmitter is calibrated at the factory. Do not change calibration settings unless absolutely
required.
While the
Calibrate Analog Meter
page is displayed, the meter will only deflect to full or half
scale. Exit the
Calibrate Analog Meter
page to return the meter to normal operation.
10:18 0.00kW M-1 B+1 PM:A Man Ex:A Man
B+ Voltage: 300 V
0 200 400
Scale Factor: 4.7270000e-01
Use the arrow keys to select a meter.
Press EDIT to adjust this meter.
Edit Back
10:18 0.00kW M-1 B+1 PM:A Man Ex:A Man
B+ Voltage: 300 V
0 200 400
Scale Factor: 4.7270000e-01
Use the arrow keys to select a meter.
Press EDIT to adjust this meter.
Edit Back