Nautel VX150, Operation & Maintenance Manual

Page: 20 / 179

VX150 TO VX2 OPERATIONS & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
VERSION 1.0 2022-12-08 PAGE 2.2.3
User Interfaces
NOTE
:
Nautel recommends you make a complete backup clone of the transmitter’s SD card in the event
the SD card in the transmitter becomes corrupted or damaged. Use a Class 10 SD card with a minimum
8 GB capacity (e.g., Nautel part number UB114, vendor part number Cactus KS8GR-245, or equivalent).
The user can interface with the VX150 to VX2 using one of three methods:
 Remotely, via a LAN connection, using the Advanced User Interface (AUI) pages (see Advanced User
Interface (AUI) ). You can enable remote control from the front panel by pressing the Remote button,
which will turn green when enabled.
 Locally, using the transmitter’s Front Panel UI and its rotary button (see Front Panel User Interface
(FPUI), on page 2.2.86 ).
 Remotely, via remote input/output (I/O) wiring connected to the rear of the transmitter to the
remote I/O D-sub connectors on the real panel (see
Remote I/O, on page 2.2.71 for AUI or Remote I/
O, on page 2.2.130 for FPUI). Refer to the VX150 to VX2 Installation Manual for I/O details).
See the complete menu hierarchy illustrated in Figure 2.2.2 (for the remote AUI menu) and Figure 2.2.3
(for the Front Panel UI menu). When a user interfacing function can be performed from both the AUI
and the Front Panel UI, both are described in this section.