V10/V7.5/V5/V3.5 Installation and Operation Manual
Page
3-13
Section 3 Operating Instructions
Issue 3.5
Table 3-5a:
Interconnect PWB - Controls and Indicators
PANEL
MARKING
DESCRIPTION
S1
12-position dipswitch, which is set to configure and identify its
interconnected module (see Table 3-5b for switch settings).
S2
4-position dipswitch, which is set to configure and identify its
interconnected module (see Table 3-5b for switch settings).
For the V10, there are up to ten electrically identical interconnect PWBs
[A17, A18 (optional) and A23 through A30] used in conjunction with IPA
modules ‘A’ and ‘B’ and RF power modules ‘A’ through ‘H’.
For the V7.5, there are up to eight electrically identical interconnect PWBs
[A17, A18 (optional) and A23 through A25 and A27 through A29] used in
conjunction with IPA modules ‘A’ and ‘B’, RF power modules ‘A’ through
‘C’ and ‘E’ through ‘G’.
For the V5, there are five electrically identical interconnect PWBs (A17 and
A23 through A26) used in conjunction with the IPA module and RF power
modules ‘A’ through ‘D’.
For the V3.5, there are four electrically identical interconnect PWBs (A17
and A23 through A25) used in conjunction with the IPA module and RF
power modules ‘A’ through ‘C’.
The interconnect PWBs are located at the rear of the associated module. Remove the associated
module to gain access to the switches.
Each switch should be set according to the following table (silkscreened switch markings are in
BOLD text).
Check the XMTR USAGE column of Table 3-5b to determine which interconnect PWBs are used
for a particular V series transmitter.