Nautel NX5 AM, Operation & Maintenance Manual

Page: 115 / 220

NX5 OPERATION & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
VERSION 0.1 2015-08-01 PAGE 3.2.95
Notifications
NOTE
: This function is only available via the remote AUI.
The
Notifications
feature (see Figure 3.2.82 ) provides a means for the transmitter to issue emails
triggered by user defined alarm events. If you use this feature, you must also configure an email (see
Email Configuration, on page 3.2.93 ).
Figure 3.2.82: Notifications page
To configure the notifications feature, perform the following steps:
1. Pre-existing notifications are displayed in the Notifications list (e.g., “LVPS Failures”. Click Add to
create a new item for notification, click
Edit
(after highlighting an existing item) to edit an existing
item or click Delete to erase an item.
2. When you click Add or Edit , the screen in Figure 3.2.83 will appear. This screen allows you to add
or edit a Notification Name , Recipient Email , and define the alarm list by Device type
(Controller, Exciter A or B, Rack #or RF Module #). Add or remove alarms by moving them (using
the >> and << arrow buttons) from the Available Alarms list to the Selected Alarms list. An email
is issued when any alarm in the Selected Alarms list is active.
3. When complete click the OK button to accept changes or the Cancel button to discard changes
and return to the Notifications page.