Nautel NX15, Operation And Maintenance Manual

Page: 147 / 178

NX15/NX25 Operations and Maintenance Manual Operating the transmitter
Issue 6.0 2019-01-31 Page 2-123
Remote inputs
In the
Remote I/O
page, use the
Inputs
tab parameters (see Figure 2.94 ) to configure up to 16
remote inputs that allow you to remotely control various operational characteristics of the
transmitter.
Unless otherwise noted these inputs are only accepted by the transmitter if the
Remote/Local
status (bottom panel of any AUI page) is set to
Remote
. That setting can only be selected by a
local user using the front panel AUI.
Nautel sets remote input defaults prior to shipping. See the NX15/NX25 Pre-installation
Manual for details. If necessary, re-configure the remote inputs as follows:
Figure 2.94: Remote I/O Input Parameters
1. On the left side of the page, select the desired remote input (1 through 16) from the list.
Note: you can configure remote inputs 1 through 16 for one of a variety of control
inputs.
2. On the right side of the page, assign a name to the digital input by pressing the
Channel
bar and selecting one of the following options:
•
Not Assigned
- has no effect on transmitter operation, regardless of logic level.
•
RF On/Off
- tells the system to provide RF power, if possible (same as pressing the
RF
On
or the
Rf Off
button on the AUI).
•
Reset
- causes a system reset.
Input tab
Exit page
Current
logic level