Nautel NV7.5, Operation And Maintenance Manual

Page: 133 / 183

NV10/NV7.5 Operations and Maintenance Manual Operating the transmitter
Issue 3.4 2016-08-03 Page 2-101
• Select an existing notification and press
Delete
to remove a notification from the
list.
The window that opens for both
Add
and
Edit
allows you to edit a notification
name, one or more recipient email addresses (separated by a semicolon), and the
notification device. Use the arrows (
>>
and
<<
) to select alarms by moving them
from the
Available Alarms
list to the
Selected Alarms
list.
4. Repeat the previous step, as required, for each notification.
5. When finished, press
OK
to accept your entries or press
Cancel
to ignore your changes
and exit this window.
Configuring exgine settings
The
Exgine Settings
page allows you to set signal parameters and determine IP information for
use with the Exgine option (see Figure 2.68 on page 2-102 ).
Procedure to configure
Exgine Settings
:
1. Open the
User Settings
page by pressing
Menu/User Settings
in the
Home
page.
2. Select the
Exgine Settings
option (left-side of the screen) to display a list of pre-existing
notifications on the right-side of the screen. Press
Refresh
to ensure that the latest
Exgine configuration information is loaded.
3. Enter the following parameters (if applicable) and press
Apply
.
•
Digital Carriers
- Select On or Off.
•
Protocol
- Selects the E2X protocol to use UDP (default) or TCP. Match this
setting to the Exporter configuration.
•
Exgine IP
,
Netmask
and
Gateway
- Configure the Exgine's IP network parameters
as assigned by the local network administrator. If no gateway is used or assigned,
enter 0.0.0.0.
•
Exporter IP
- Enter the Exporter's IP address of the interface where the data stream
is originating. It is used to filter E2X traffic in case multiple exporters are used in
broadcast mode on a single LAN. 0.0.0.0 is also a valid configuration.