Nautel GV3.5, Operation & Maintenance Manual, Page: 159 / 251

GV5/GV3.5 OPERATIONS & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
PAGE 3.2.142 VERSION 0.2 2014-07-23
Connecting a Laptop Directly to the Transmitter
If connecting to the GV5/GV3.5 directly with a laptop, you must set a static IP address on the GV5/
GV3.5 and your laptop.
1. From the controller UI’s
Main Menu
, go to
User Settings -> Network Settings
and set the IP
address as follows:
 DHCP: OFF
 IP Address: 10.10.10.2
 Netmask: 255.255.255.0
2. Set the transmitter for
Remote
control.
NOTE
: The following steps assume the operating system is Windows XP. Adapt as required for
computers with different operating systems.
3. On the laptop, go to
Start Menu
/
Control Panel
/
Network Connections
/
Local Area Network
.
4. In the Local Area Network Status, open the
General
tab and choose
Properties
. Scroll down and
highlight
Internet Protocol (TCP/IP)
. Choose
Properties
.
5. In the Internet Protocol (TCP/IP) Properties window, select
Use the following IP address
.
6. Enter the following settings:
 IP Address: 10.10.10.1
 Subnet Mask: 255.255.255.0
 Default Gateway: 192.168.1.2
7. In the Internet Protocol (TCP/IP) Properties window, select
OK
.
8. In the Local Area Connection Properties window, select
OK
.
9. In the Local Area Connection Status window, select
Close
.
10. Close the Network Connections window.
11. Enter the IP address (10.10.10.2) into a web browser’s address bar to connect to the transmitter’s
remote AUI.