Nautel GV3.5, Operation & Maintenance Manual, Page: 104 / 251

GV5/GV3.5 OPERATIONS & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
VERSION 0.2 2014-07-23 PAGE 3.2.87
Figure 3.2.68: RDS Settings editing screens (1 of 3)
Use the up and down buttons to select Select Internal, ASCII,
Ext. UECP, ASCII Over IP, or UECP Over IP, then press the
accept (checkmark) button to save the change. Press the
cancel (
X ) button to discard changes and return to the previ-
ous menu. Default setting is UECP.
NOTE
:
For an ASCII Over IP data source, RDS information
should be sent to the IP address of the GV5/GV3.5, port 7005.
NOTE
:
For title/artist functionality, the GV5/GV3.5 supports
the radiotext (RT) data type, using the UECP or Ext. ASCII data
source.
Use the up and down buttons to select ON or OFF, then press
the accept (checkmark) button to save the change. Press the
cancel (
X ) button to discard changes and return to the previ-
ous menu. Default setting is OFF.
Use the up and down buttons to select Select 150 bps,
300 bps, 600 bps, 1.2 kbps, 2.4 kbps, 4.8 kbps, 9.6 kbps,
19.2 kbps, 38.4 kbps, 57.6 kbps or 115.2 kbps, then press the
accept (checkmark) button to save the change. Press the
cancel (
X
) button to discard changes and return to the previ-
ous menu. Default baud rate is 19.2 kbps.
Use the up and down buttons to select a level between 0 and
10% (in 0.1% increments), then press the accept (checkmark)
button to save the change. Press the cancel (
X ) button to
discard changes and return to the previous menu. Default
level is 0.0%.
Use the up and down buttons to select a phase angle be-
tween 0 and 360 degrees (in 0.1 degree increments), then
press the accept (checkmark) button to save the change.
Press the cancel (
X
) button to discard changes and return to
the previous menu. Default level is 0.0 degrees.