Single Use Pre-
Sized XactTrace™ Belt System User Instructions
3
System Components
The system consists of a belt and a snap sensor with a cable that
connects directly to an input on the recording device. The system
converts changes in inductance to a digital signal that provides both
qualitative and quantitative information on respiratory effort. An optional
RIP Processor can be purchased to interface the locks with most PSG
systems that accept the 1.5mm female touchproof connectors.
Belt
Sensor
Fitting the XactTrace Belts
The belts are intended to be worn over nightclothes and should fit the
patient snugly without being uncomfortably tight. Avoid all unnecessary
contact with moisture when using the Single Use Pre-Sized XactTrace
belt system.
Note:
Do not use two thorax sensors or two abdomen
sensors in the same recording. Using two sensors of the
same type will cause interference between the sensors and
could result in poor signal quality.
