ErgoJust Cart Installation Instructions
3-10
July 14, 2016
Mounting the Natus Photic Stimulator (option)
1. Insert the optional Natus Photic Stimulator mounting post into the accessory bar (Figure 1). It
may be located on either side of the main post.
2. Tighten the securing knob to secure the post.
3. Route the power cable down to the cart base and secure the power supply with Velcro
Figure 1: Mounting the Natus Photic Stimulator (option) swivel arm.
Mounting the Natus Amplifier Base Unit
NOTE:
Ensure the amplifier base unit has a Headbox Side Quick Disconnect Bracket attached.
1. Insert the four mounting pins on the rear of the Amplifier Base Unit into the four mounting
holes on the video pole side quick disconnect bracket (Figure 1) and slide the Amplifier Base
Unit downward until the locking pin snaps into the quick disconnect bracket locking hole.
2. To remove the Amplifier Base Unit, pull the locking pin out to the Release position and slide
the Amplifier Base Unit upward and pull away from the cart.
