ErgoJust Cart System
August 22, 2017
3-17
Replacing a damaged
handle
NOTE:
If the handle requires replacement, continue with
Replacing a damaged handle
on this
page. If the handle is not damaged, go to
Installing the new basket
on the next page.
a. Loosen the four handle screws and slide the handle up and out from the bottom mast
(Figure a).
Figure a: Loosen the four mounting screws.
b. Remove the screws from the handle mounting plates and set the damaged handle aside.
IMPORTANT
: Ensure the two mounting plates are orientated properly as shown in Figure b
before starting the next step.
Figure b: Proper mounting plates orientation.
c. Insert each of the mounting screws through the handle and thread the screws into the
mounting brackets until the ends of the screws are flush with the back side of the brackets
(Figure c).
Figure c: Thread both screws until they are flush with the bracket.
d. Slide the handle mounting plates into the bottom mast grooves.
e. Adjust the height of the handle as desired and tighten all four of the mounting plates
screws.