VII. Data Management
ALGO
®
3i Newborn Hearing Screener IFU 024913 RevD Revision Date 08/05/2020
37
To print ALL screening records:
1. Select DataManagement from the MainMenu.
2. Scroll down to “Print All Records” and click OK.
3. The ALGO 3i screener will display a message showing the number of records stored
and confirming your intention to print.
4. Ensure that the printer is turned on and that the printer IR port or dongle is positioned
in clear view of the IR port on the ALGO 3i screener. The printer IR port/dongle
should be no closer than 6 inches (15cm) from the ALGO 3i device’s IR port. Click OK
to proceed.
5. The ALGO 3i screener will display a “Printing in Progress” message. Printing may take
a few minutes. Monitor the printer until you see the first record begin to emerge.
a. You may click “X” to cancel printing at any time.
6. After the ALGO 3i screener has sent all records to the printer, it will display the “Data
Sent to Printer” message and ask you to click OK.
7. You will be returned to the DataManagement menu.
Note:
The ALGO 3i screener does not receive any feedback from the printer. This means that the ALGO
3i screener will send data to the printer, even if the printer is not turned on, or not printing. Be sure to
monitor printing to ensure that all records print.
To print SELECTED screening records:
1. From MainMenu, select DataManagement.
2. Select records you wish to print (see above “Selecting Records”).
3. From DataManagement, scroll down to “Print Selected Records”. Click OK. The
ALGO 3i screener will display the number of records selected and ask you to confirm
your intent to print these records.
4. Follow steps 4 – 7 under the “To print ALL screening records” section.
Data Export to a PC
The ALGO 3i screener allows you to export all, or any subset of the records stored in the device
to a personal computer (PC). To perform data export, the ALGO 3i DUS (Data Utility Software)
option is required and must be installed onto the PC. The Natus data export dongle must be
attached to the PC to receive the exported data from the ALGO 3i screener’s IR port. Please
refer to Natus Technical Notice (ALGO 3i Export Option.doc) located on the CD delivered with
your ALGO 3i screener, and contact your local service representative for more information.
Note:
Once a record has been exported, an “exported” symbol will appear next to the record in the
records review area, and the record will appear as follows:
