9
Installation and Maintenance Manual
9. WATER INLET/FILTRATION INSTALLATION / FILTER INSTALLATION:
STEP 2
3/8” ELBOW
3/8” ELBOW
10
9
FILTER SET
FILTER MANIFOLD
Pre-Sediment Filter (Inlet Side) Carbon Filter NanoCeram® (Outlet Side)
WARNING: DO NOT USE WITH WATER THAT IS NOT MICROBIOLOGICALLY SAFE OR OF
UNKNOWN QUALITY.
ATTENTION: IT IS IMPORTANT TO MAKE PROPER CONNECTIONS TO THE QUICK CONNECT
FITTINGS TO AVOID LEAKS. SEE PAGE 3.
CAUTION: DO NOT PLACE UNDUE STRESS OR SIDE LOAD ON ANY OF THE PLASTIC
FITTINGS.
1.
Place the Countertop Water Dispenser or Remote Chiller no more than 10 feet from
the water source. Place the Filter Set exactly between the two.
2.
Mark the Filter Set inlet and outlet on the Filter Bracket and Filter Housings before
securing the Filter Bracket to the Filter Manifold.
3.
Secure the Filter Bracket to the wall or other structure using the proper fasteners. The
Filter Bracket can be turned over for space requirements. The mounting holes will be
located behind the Filter Head in this con
fi
guration.
4.
Assemble 3/8” Elbow Fittings to inlet and outlet ports on Filter Manifold.
5.
Install the Filters into the Filter Housings. NOTE: ENSURE THE PROTECTIVE PLASTIC
WRAPPERS ARE REMOVED FROM THE FILTERS. The Pre-Sediment Filter (white)
is assembled on the left. The Carbon Filter (black with netting) is located in the
center. The Nano Ceram Filter (pleated with netting) is located on the right. Ensure
the cartridge slips over the stand pipe in the bottom of the housing. Hand tighten.
DO NOT OVER TIGHTEN.
NOTE:
ON TOP OF THE PLASTIC FILTER
MANIFOLD THE INLET &
OUTLET PORTS ARE MARKED.
FOR PROPER OPERATION THIS
CONFIGURATION IS REQUIRED.
IN
OUT
INLET
OUTLET
FILTER BRACKET
