4. SETTING UP TRAKTOR KONTROL S4
By this section, you should have already installed TRAKTOR PRO 3 software using NATIVE AC-
CESS, in order to configure the S4 for its first use. If this is not the case, follow the instructions
under this link
Registering and Installing a Native Instruments Product using NATIVE ACCESS
This section describes how to set up the TRAKTOR KONTROL S4. When all devices are connec-
ted your setup will look like the following illustration:
TRAKTOR KONTROL S4 setup.
4.1. Connecting to the Computer
To connect the TRAKTOR KONTROL S4 to your computer:
1.
Connect the device end of the included USB cable to the USB socket on the rear panel of
your S4.
2.
Connect the computer end of the USB cable to an available USB 2.0 port (or later) on your
computer.
Setting up TRAKTOR KONTROL S4
8
Summary of Contents for TRAKTOR KONTROL S4
Page 1: ......
