MASCHINE 1.5 Reference Manual – 188
11.1.2 Editing a Sample (Hardware)
With Button 2 you can reach the Edit Tab to edit the Sample. Here you can edit the start and
end point of the Sample and create a Loop for it. Use Knob 5 to zoom in on the waveform
of the Sample and Knob 6 to navigate through it.
Page 1: Trim
The Sample Editor on the hardware.
S
tart
Using Knob 1 you can adjust the start point of the Sample
here.
E
nd
Using Knob 2 you can adjust the end point of the Sample here.
Page 2: Loop
Setting a Loop within a Sample on the hardware
l
oop
m
odE
Here you can choose to either disable or enable Loop Mode
by dialing Knob 1. If enabled, you can see the Loop high-
lighted on the Right Display (as pictured above). The Loop
will be repeated as long as the note is triggered, which
can be useful to loop either a whole Sample or part of it to
simulate a longer tone.
S
tart
Define the start point of the Loop with Knob 2.
E
nd
Defines the end point of the Loop with Knob 3.
C
roSSFadE
Crossfade (Knob 4) allows you to blend a little of the ma-
terial near the loop start and end points in order to get a
smoother, less abrupt loop. This is particularly helpful if
the loop is inducing any clicks.
Summary of Contents for Maschine
Page 1: ...REFERENCE MANUAL...
