Native Instruments MASCHINE MK3, Manual, Page: 56 / 891

▪
MASCHINE STUDIO controller: Press SHIFT + PLUG-IN , turn the jog wheel to select the
desired instance, and press the jog wheel or Button 8 to load it.
▪
MASCHINE (MK3) controller: Press SHIFT + PLUG-IN , turn the 4-D encoder to select the
desired instance, and press the 4-D encoder or Button 4 to load it.
▪
MASCHINE (MK2) controller: Press SHIFT + STEP , turn Knob 5 (or press Button 5/6) to
select the desired instance, and press Button 8 to load it.
▪
MASCHINE MIKRO (MK2) controller: Press SHIFT + F2 , turn the Control encoder to select
the desired instance, and press the Control encoder to load it.
2.3.10 Touch Auto-Write Option
Modulation recording also benefits from the touch sensitivity of Knobs 1–8 via the Touch Auto-
write option.
Reminder: To record modulation from your MASCHINE controller, activate playback,
switch your controller to Auto-write mode by pressing and holding
AUTO , and then turn
the Knobs 1–8 to adjust parameters. For more information, please refer to section
↑
7.5.2, Recording Modulation .
Enabled by default, the Touch Auto-write option allows you to record modulation events as
soon as you touch Knobs 1–8, even if you don’t rotate them:
▪
If Touch Auto-write is disabled, modulation events are recorded only when you rotate the
Knobs 1–8 (as in previous MASCHINE versions).
▪
If Touch Auto-write is enabled, modulation events are recorded as soon as you touch the
Knobs 1–8, whether you actually rotate them or not:
◦
If you rotate the Knobs, the new modulation values are recorded for the corresponding
parameters.
◦
If you touch the Knobs but don’t rotate them, the last modulation values for these pa-
rameters keep being recorded as new events as the playhead moves forward, thereby
overwriting any existing modulation events at the playhead position. Modulation stops
being recorded when you release the Knob(s).
Basic Concepts
Common Operations
MASCHINE - Manual - 56