Native Instruments MASCHINE MK3, Manual, Page: 347 / 891

1. Press SETTINGS to show the recording settings.
2. Turn Knob 1 ( Metronome LEVEL ) to adjust the metronome volume.
3. Turn Knob 2 ( Metronome TIME ) to select a time signature.
While adjusting the metronome settings you can enable/disable the metronome via But-
ton 2 ( METRO ). This is strictly equivalent to pressing SHIFT + TAP ( Metro ) as men-
tioned above.
7.2.4 Recording with Count-in
Count-in allows you to start the metronome before the sequencer and recording begins. This is
very handy if you want to start recording a Pattern exactly on the downbeat.
When recording starts with a Count-in, the following happens:
▪
The playhead jumps to the beginning of the Loop Range.
▪
You hear the metronome alone during the count-in phase (1, 2 or 4 bars).
▪
After the count-in phase, the recording starts in Overdub mode (see
↑
7.2.1, Recording
Your Patterns Live ). The metronome turns off if it was off before the Count-in, otherwise it
stays on.
You can adjust the metronome’s volume, time signature, and downbeat/upbeat sounds.
See section
↑
7.2.3, Using the Metronome for more information.
Working with Patterns
Recording Patterns in Real Time
MASCHINE - Manual - 347