Native Instruments KOMPLETE KONTROL, Manual

Page: 234 / 258

▪
For information about Octaves and the range of the arpeggiator, see section
↑
7.7.6, Oc-
taves .
▪
For information about Dynamic and creating velocity variations, see section
↑
7.7.7, Dynam-
ic .
▪
For information about Gate and setting note length, see section
↑
7.7.8, Gate .
▪
For information about Hold and latching the playback, see section
↑
7.7.9, Hold .
For information on Scale parameters, see section
↑
7.5, Scale Parameters .
7.7.1 Mode
The Arp parameter Mode , default value Arp .
The first MAIN parameter on the keyboard corresponds to the Mode parameter in the software.
The first Arp parameter is Mode . On the keyboard, the Mode setting is displayed as the first
MAIN parameter, mapped to Knob 1 of the Control section. lt lets you select either Arp or
Note Repeat . Depending on your selection, a different set of Arp parameters will be available
for further editing.
The
Mode setting consists of the following two modes, which are described in detail below:
▪
Arp , giving you access to all Arp parameters.
▪
Note Repeat , giving you access to the Arp parameters Rate , Swing , and Gate .
KOMPLETE KONTROL Smart Play
Arp Parameters
KOMPLETE KONTROL - Manual - 234