Note that depending on the assignment properties for each of the Knobs, its displayed value
(or bar) can either be going from 0 to 127 or from -63 to 64 (bipolar) — this second setting
can be useful for some types of controls (e.g. a stereo balance). This only affects the value/bar
shown on the displays — the real MIDI value will go from 0 to 127 anyway. Please refer to
section
25.6.8, Assignments for Analog Encoders
The
MCU Mode
check box allows you to set your MASCHINE STUDIO controller displays
to MCU mode in order to receive Mackie Control feedback from your DAW while keeping
the original assignment of the Buttons and Knobs in the Knob Page area. The
MCU
Mode
setting applies Page-wide.
9.4.5
Pages Display Mode
The Pages display mode allows you to check the current assignations for the Knobs, Pads, I/O
and Level Knob and the Jog Wheel of your MASCHINE STUDIO controller, by mirroring the
current Pages:
The Pages display mode mirrors the Pages currently loaded.
Across the two displays you will find four columns, each representing a list of Pages (Knobs,
Pads, I/O and Level and the Jog Wheel). Use Knobs 1–8 to select a different page and press
the button (
LOAD
) directly above the column to load the selected page for example, to load a
new Knob Page:
1.
Use Knob 1 to scroll through the list and find the Knob Page you wish to load.
2.
When you have made your selection, press the Button 2 (
LOAD
) to load the selected Knob
Page.
Using Your MASCHINE STUDIO Controller
The Displays
CONTROLLER EDITOR - Manual - 123
Summary of Contents for komplete kontrol s series
Page 1: ......
