AUDIO KONTROL 1 – 94
Continuous Switch
: This switch activates the
Continuous Mode
: Normally, a key
command is generated by simulating a key being pressed and released imme-
diately afterwards. This keystroke is sufficient in most situations. However,
sometimes it is necessary to simulate a key that is held down for a given time.
This can be simulated with the Continuous Mode. It simulates the key being
pressed when the hardware event arrives, for instance when the knob is rotated
in either direction. But instead of simulating the key release immediately af-
terwards, the release is only generated when the knob stops moving. Thus, the
key is “held” until the rotation ends. Due to this structure, the Continuous
Switch can only be activated for Rotate events and for the Press event of the
Trigger mode, i.e. not for Release, On or Off.
If
MIDI
is selected in the
Software Event Type menu
, the Specification Area provides
you with the MIDI Message parameters to be sent
The MIDI Messages are sent using a second, virtual MIDI port. The ap-
plication you want to remotely control with MIDI messages needs to be
connected to that virtual MIDI port - make sure that the target software’s
MIDI interface is setup correctly.
Specification Area for the
MIDI
Software Event Type.
►
