Assembly Instructions
Eloquence™ Series
Ganging Center and
Corner Tables
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent. If you
have any questions concerning these instructions, please call National Customer Service.
S E A T I N G
1
Figure A
Telephone 800.482.1717
Fax 812.482.8800
www.nationalonline.com
Part #2064345
Printed in U.S.A
© 2007 Kimball International, Inc.
Ganging Center Table:
Position chairs to be ganged evenly
apart (approximately two feet) so that the
table will be able to rest on side rails of each
chair (Figure A).
2
With angled shims on table toward rear,
position table so it rests on the side rails
of each chair. Squeeze chairs inward
toward table for tight fit. Observe that
table top is level to floor. If not, check
that angled shims are toward rear of
chairs (Figure B).
Recommended Tools
• Cordless Drill
Figure B
Package Contents
Qty.
• Center/Corner Ganging Table 1
• U-Brackets
4
• #10 x 3/4” Screws
16
3
Figure C
On one side, place two (2) U-brackets over
the side rails of both chair and table.
Note: U-brackets are NOT symmetrical.
When placing U-brackets, make sure
holes line up on center of both table
and chair rails.
Repeat for other side (Figure C).
4
Using a cordless drill, insert four (4)
#10 x 3/4” screws in the U-bracket
(Figure D).
Figure D
5
Repeat Step 4 to fasten remaining
U-brackets.
6
Figure E
After U-brackets are installed, inspect
that table top is tightly secured and
level with floor (Figure E).
