©
National Instruments Corporation
3-1
Getting Started with Your VXIpc 800/700
Chapter
3
Default Settings
This chapter summarizes the hardware and software default settings
for the VXIpc 800/700 Series kit. Because you can also access the
VXI/VME-MXI-2 Configuration Editor to configure a VXI-MXI-2
or a VME-MXI-2 through the
VXIedit
program, this chapter also
summarizes the software default settings for the VXI/VME-MXI-2. If
you need more information about a particular setting or if you want to
try a different configuration, refer to the hardware and software
manuals in your kit.
Refer to the VXIpc 800/700 Series User Manual for more detailed
information about the hardware default settings and options. The
NI-VXI Software Manual for the VXIpc 800/700 Series contains more
details about the NI-VXI software default settings and options.
Table 3-1.
VXIpc 800 Series Hardware Default Settings
Hardware Component
Default Setting
S1—Ethernet EEPROM
Enabled. Do not alter this setting.
S2—Power On Self
Configuration (POSC)
Enabled. Do not alter this setting.
S3—CLK10 Source
Source from onboard oscillator
S4—CLK10 SMB Polarity
Not inverted
S5—CLK10 SMB Direction
Receive CLK10
S6—CLK10 SMB Termination
Do not terminate
S7—TrigIn SMB Termination
Do not terminate
S8—GPIB Circuitry Interrupt
Level 11
S9—MITE Configuration
EEPROM
Load values from user section
