©
National Instruments Corporation
5
SCXI-1325 Installation Guide
Figure 2 shows the SCXI-1325 signal connections.
Figure 2.
SCXI-1325 Signal Connections
Installation
To connect the terminal block to the SCXI module front connector, perform
the following steps:
1.
Connect the module front connector to its mating connector on the
terminal block.
2.
Tighten the top and bottom thumbscrews on the back of the terminal
block to hold it securely in place.
Cleaning the Terminal Block
Clean the terminal block by brushing off light dust with a soft, nonmetallic
brush. Remove other contaminants with deionized water and a stiff
nonmetallic brush. The unit must be completely dry and free from
contaminants before returning to service.
1
Serial Number
2
Wire Entry Side
3
Assembly Number
4
Product Name
1
2
3
4
SUPPL
Y
ISINK
V
OUT
GND
SUPPL
Y
ISINK
V
OUT
GND
SUPPL
Y
ISINK
V
OUT
GND
SUPPL
Y
ISINK
V
OUT
GND
SUPPL
Y
ISINK
V
OUT
GND
SUPPL
Y
ISINK
V
OUT
GND
Summary of Contents for SCXI-1325
Page 9: ......