2-18
|
ni.com
Chapter 2
Installation and BIOS Setup
The options for Serial Port 2 are
Use Automatic Settings
, (IO=2F8h; IRQ=3; DMA),
(IO=3F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12; DMA), (IO=2F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12;
DMA), (IO=3E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12; DMA), and (IO=2E8h; IRQ=3, 4, 5, 6, 7,
9, 10, 11, 12; DMA).
Serial Port 2 Attribute (Available for Serial Port 2 only)
Select SOL to use COM Port 2 as a Serial_Over_LAN (SOL) port for console redirection.
The options are
COM
and
SOL
.
PCH-FW Configuration
The following firmware information will display:
•
ME FW Version
•
ME Firmware Mode
•
ME Firmware Type
•
ME Firmware SKU
ME FW Image Re-Flash
Use this feature to update the Management Engine firmware. The options are
Enabled
and
Disabled
.
AMT Configuration
Intel AMT
Select Enabled to use Intel AMT (Active Management Technology) to enhance system
performance. The options are
Enabled
and
Disabled
.
BIOS Hotkey Pressed
Select Enabled to use the BIOS Hotkey feature. The options are
Enabled
and
Disabled
.
Watch Dog
Select Enabled to allow AMT to reset or power down the system if the operating system or
BIOS hangs or crashes. The options are
Disabled
, and
Enabled
.
OS Timer / BIOS Timer
These options appear if Watch Dog Timer (above) is enabled. This is a timed delay in
seconds, before a system power down or reset after a BIOS or operating system failure is
detected. Directly enter the value in seconds.
