© National Instruments
|
2-5
Wait For “F1” If Error
This option forces the system to wait until <F1> is pressed if an error occurs. The options are
Disabled
and
Enabled
.
Hit “Del” Message Display
This option displays
Press DEL to run Setup
during POST. The options are
Enabled
and
Disabled
.
Watch Dog Function
If enabled, the watch dog timer allows the system to reboot when it is inactive for more than
5 minutes. The options are
Enabled
and
Disabled
.
Power Button Mode
Use this option to decide whether the power button turns off the system instantly or waits
4 seconds when pressed. The options are
Instant Off
and
4 Seconds Override
.
Restore on AC Power Loss
Use this option to set the power state after a power outage. Select
Power-Off
for the system
power to remain off after a power loss. Select
Power-On
for the system power to be turned on
after a power loss. Select
Last State
to allow the system to resume its last state before a power
loss. The options are
Power-On
,
Power-Off
, and
Last State
.
Interrupt 19 Capture
Interrupt 19 is the software interrupt that handles the boot disk function. When you set this item
to
Enabled
, the host adaptors ROM BIOS “captures” interrupt 19 at boot and allows the drives
attached to these host adaptors to function as bootable disks. If you set this item to
Disabled
, the
host adaptors ROM BIOS does not capture interrupt 19, and the drives attached to these adaptors
do not function as bootable devices. The options are
Enabled
and
Disabled
.
Processor and Clock Options
Caution
Be careful when changing the advanced settings. An incorrect value, very
high DRAM frequency, or incorrect DRAM timing may cause the system to become
unstable. If this occurs, revert to the default setting.
CPU Ratio
Use this option to use the CPU clock multiplier to multiply CPU speed to enhance performance.
Select
Manual
to set the multiplier setting manually. Select
Auto
for the BIOS to select the CPU
multiplier setting for your system automatically. The options are
Default
and
Manual
.
Clock Spread Spectrum
Select
Enable
to use the clock spectrum feature, which allows the BIOS to monitor and reduce
the electromagnetic interference level that the components cause. Select
Disabled
to enhance
system stability. The options are
Disabled
and
Enabled
.
