© National Instruments
|
2-1
2
Installation and BIOS Setup
This chapter describes how to install, configure, and use the NI RMC-8354.
Before connecting the NI RMC-8354 to a power source, read this chapter and the
Read Me First:
Safety and Electromagnetic Compatibility
document included with your NI RMC-8354.
Safety Information
Caution
Before undertaking any troubleshooting, maintenance, or exploratory
procedure, carefully read the following caution notices.
Caution
Overloading the circuits may damage supply wiring. Do not exceed the
ratings on the equipment nameplate when connecting equipment to the supply circuit.
Caution
Risk of explosion if battery is replaced by an incorrect type. dispose of
used batteries according to instructions.
This equipment contains voltage hazardous to human life and safety, and is capable of inflicting
personal injury.
•
Chassis Grounding
—The NI RMC-8354 requires a connection from the premise wire
safety ground to the NI RMC-8354 chassis ground. The earth safety ground
must
be
connected during use of this equipment to minimize shock hazards. Refer to the
section for instructions on connecting safety ground.
•
Live Circuits
—Operating personnel and service personnel must
not
remove protective
covers when operating or servicing the NI RMC-8354. Adjustments and service to internal
components must be undertaken by qualified service technicians. During service of
this product, the mains connector to the premise wiring must be disconnected. Dangerous
voltages may be present under certain conditions; use extreme caution.
•
Explosive Atmosphere
—Do
not
operate the chassis in conditions where flammable gases are
present. Under such conditions, this equipment is unsafe and may ignite the gases or gas fumes.
•
Parts Replacement
—Service this equipment only with parts that are exact replacements,
both electrically and mechanically. Contact National Instruments for replacement part
information. Installation of parts with those that are not direct replacements may cause
harm to personnel operating the chassis. Furthermore, damage or fire may occur if
replacement parts are unsuitable.
•
Modification
—Do
not
modify any part of the NI RMC-8354 from its original condition.
Unsuitable modifications may result in safety hazards.
