Interior Cleaning
Use a dry, low-velocity stream of air to clean the interior of the chassis. Use a soft-bristle
brush for cleaning around components.
Exterior Cleaning
Clean the exterior surfaces of the chassis with a dry, lint-free cloth or a soft-bristle brush. If
any dirt remains, wipe with a cloth moistened in a mild soap solution. Remove any soap
residue by wiping with a cloth moistened with clear water. Do not use abrasive compounds on
any part of the chassis.
Caution
Avoid getting moisture inside the chassis during exterior cleaning,
especially through the top vents. Use just enough moisture to dampen the cloth.
Do not wash the front- or rear-panel connectors or switches. Cover these
components while cleaning the chassis.
Do not use harsh chemical cleaning agents; they may damage the chassis. Avoid
chemicals that contain benzene, toluene, xylene, acetone, or similar solvents.
Replacing a Modular Power Supply
This section describes how to remove and install a modular power supply for the
PXIe-1086DC chassis.
Caution
Disconnect the power cable prior to replacing the power supply.
Attention
Débranchez le câble d'alimentation avant de remplacer le bloc
d'alimentation.
Caution
Do not use a power supply from another chassis. Doing so may damage
your chassis and the power supply. You must ensure the chassis is properly grounded
after any maintenance.
Attention
N'essayez pas d'utiliser un bloc d'alimentation provenant d'un modèle de
châssis différent du vôtre. Cela pourrait endommager votre châssis et le bloc
d'alimentation.
Connecting to Safety Ground and Power Source
for instructions on connecting safety
ground.
Removal of Power Supply
The PXIe-1086DC power supply (part number 782106-01) is a replacement part for the
PXIe-1086DC chassis. Before attempting to replace a power supply, verify that there is
adequate clearance behind the chassis.
The power supplies for this chassis are redundant and hot swappable. If both power supplies
are installed and functional, you can remove either without disconnecting main AC power
PXIe-1086DC User Manual and Specifications
|
© National Instruments
|
29
