©
National Instruments Corporation
I-1
PXI-8150 Series User Manual
Index
A
address map, I/O (table), B-3 to B-4
B
BIOS. See also CMOS.
checking settings, E-2
default setup settings, 4-1
entering BIOS setup, 4-1
bulletin board support, F-1
C
CMOS. See also BIOS.
configuring, 3-4
default jumper and switch settings
(table), 3-1
setting back to default, E-3
switch settings (figure), 3-4
COM1 and COM2 connectors
location and pinout (figure), D-8
overview (table), 1-6
signals (table), D-8 to D-9
common questions and answers, E-1 to E-3
configuration, 3-1 to 3-5. See also installation.
checking BIOS settings, E-2 to E-3
CMOS, 3-4, E-2 to E-3
common questions, E-2 to E-3
CPU board parts locator diagram, 3-3
default settings, 3-1 to 3-3
electrostatic discharge damage
(caution), 3-1
Ethernet power-on defaults, 3-4
installed system RAM, 3-3
parts locator diagram, 3-2
PC configuration, 3-3 to 3-5
serial IRQ, 3-5
connectors
COM1 and COM2 connector and signals,
D-8 to D-9
Ethernet connector and signals, D-7
GPIB connector and signals, D-11 to D-12
keyboard and mouse connector and
signals, D-4
overview, 1-5
parallel port connector and signals,
D-9 to D-10
peripheral expansion overview (table), 1-6
PXI connectors
location and pinout (figure), D-14
P1 connector pinouts (table), D-16
P2 connector pinouts (table), D-15
Universal Serial Bus connector and
signals, D-13
VGA connector and signals, D-5 to D-6
custom application-specific interface chips, 1-5
customer communication, xii, F-1 to F-2
D
default hardware settings (table), 3-1
DMA channel resource allocations (table), B-2
documentation
conventions used in manual, x-xi
how to use documentation set, xi
organization of manual, ix-x
related documentation, xii
DRIVE LED, 1-5, C-1
