background image

Getting Started with the NI PCIe-1433

The NI PCIe-1433 (NI 1433) is a PCI Express (PCIe) image acquisition device that supports Base, 
Medium, Full, and Extended Full configuration Camera Link-compatible cameras. The NI 1433 
supports Power over Camera Link (PoCL). This document describes how to install and configure 
the necessary hardware and software components to begin using the NI 1433.

What You Need to Get Started

You need the following items to set up and use the NI 1433:

NI 1433 image acquisition device

Camera Link-compatible camera

One 26-pin MDR Camera Link cable for Base configuration cameras

Two 26-pin MDR Camera Link cables of the same length for Medium, Full, or Extended Full 
configuration cameras

Computer running Microsoft Windows 7 (32-bit and 64-bit versions)/Vista (32-bit and 64-bit 
versions)/XP/2000 with at least one available x4 or larger PCIe slot

NI-IMAQ 4.4 or later driver software, which is included with NI Vision Acquisition Software

Optional software for developing machine vision applications:

NI Vision Builder for Automated Inspection

NI Vision Development Module, which requires one of the following application development 
environments:

LabVIEW

LabWindows

/CVI

Microsoft Visual Studio

Optional Equipment

National Instruments offers a variety of products for use with the NI 1433, including
the following:

NI Camera Link I/O Extension Board (PCIe) for additional triggering, timing and I/O
(Part number 780869-01)

SMB to BNC cable, used for front panel trigger I/O (part number 763389-01)

Visit 

ni.com

, or call the National Instruments office nearest you for specific information about these 

products.

Summary of Contents for PCIe-1433









Reviews: