© National Instruments
|
9-5
Using RTSI as Outputs
RTSI <0..7> are bidirectional terminals. As an output, you can drive any of the following signals
to any RTSI terminal:
•
AI Start Trigger (ai/StartTrigger)
•
AI Reference Trigger (ai/ReferenceTrigger)
•
AI Convert Clock* (ai/ConvertClock)
•
AI Sample Clock (ai/SampleClock)
•
AI Pause Trigger (ai/PauseTrigger)
•
AO Sample Clock* (ao/SampleClock)
•
AO Start Trigger (ao/StartTrigger)
•
AO Pause Trigger (ao/PauseTrigger)
•
10 MHz Reference Clock
•
Counter
n
Source, Gate, Z, Internal Output
•
Change Detection Event
•
Analog Comparison Event
•
FREQ OUT
•
PFI <0..5>
Note
Signals with a * are inverted before being driven on the RTSI terminals.
Table 9-1.
RTSI Signals
RTSI Bus Signal
Terminal
RTSI 7
34
RTSI 6
32
RTSI 5
30
RTSI 4
28
RTSI 3
26
RTSI 2
24
RTSI 1
22
RTSI 0
20
Not Connected. Do not connect signals to these terminals.
1 to 18
D GND
19, 21, 23, 25, 27, 29, 31, 33
Summary of Contents for PCI-6281
Page 1: ...PCI 6281...
