nuDrive Accessory User Guide
2
www.ni.com
Conventions
The following conventions are used in this manual:
This icon denotes a note, which alerts you to important information.
This icon denotes a caution, which advises you of precautions to take to
avoid injury, data loss, or a system crash.
This icon denotes a warning, which advises you of precautions to take to
avoid being electrically shocked.
♦
The
♦
symbol indicates that the following text applies only to a specific
product.
overline
Indicates the signal is active-low.
italic
Italic text denotes emphasis, a cross reference, or an introduction to a key
concept. This font also denotes text that is a placeholder for a word or value
that you must supply.
CF nuDrive
Refers to the 4CF-001 and 2CF-001 nuDrives.
CX nuDrive
Refers to the 4CX-001 and 2CX-001 nuDrives.
SX nuDrive
Refers to the 4SX-211, 2SX-211, 4SX-411, and 2SX-411 nuDrives.
stepper nuDrive
Refers to the 4SX-211, 2SX-211, 4SX-411, and 2SX-411 nuDrives.
servo nuDrive
Refers to the 4CF-001, 2CF-001, 4CX-001, and 2CX-001 nuDrives.
Introduction
Your nuDrive accessory is a complete power amplifier and system
interface for use with up to four axes of simultaneous or independent servo
or stepper motion control. Ideally suited to industrial and laboratory
applications, your nuDrive has everything you need to connect motors,
encoders, limit switches, I/O, and other motion hardware to National
Instruments motion controllers.
Summary of Contents for nuDrive 2CF-001
Page 32: ......
