Getting Started with the NI CVS-1450 Series
8
ni.com
3.
Using a standard Ethernet cable, connect from the network port to the Ethernet port on the
development computer.
Figure 5.
Ethernet Connection
Software Installation
This section contains information about installing LabVIEW, the LabVIEW Real-Time Module, the
NI Vision Development Module, and NI Vision Acquisition Software on the development computer. It
also contains information on obtaining an IP address, installing software on the NI CVS-1450 device,
and configuring the NI CVS-1450 device to acquire an image using the LabVIEW Real-Time Module.
Installation
Complete the following steps to install LabVIEW, the LabVIEW Real-Time Module, the NI Vision
Development Module, and NI Vision Acquisition Software onto the development computer.
Note
You must install LabVIEW, the LabVIEW Real-Time Module, and the
NI Vision Development Module software
before
installing NI Vision Acquisition Software.
1.
Insert the LabVIEW CD into the CD-ROM drive.
2.
When the installation screen appears, click
Install LabVIEW
,
and follow the setup instructions.
3.
Insert the LabVIEW Real-Time Module CD into the CD-ROM drive.
4.
When the installation screen appears, click
Install LabVIEW Real-Time Module
, and follow the
setup instructions.
1
Standard Ethernet Cable Connecting from the NI CVS-1450 Device to an Ethernet Hub
2
Standard Ethernet Cable Connecting from an Ethernet Hub to the Development Computer
3
Ethernet Hub or Other Network Port
3
1
2
